TRAVERSE WITH THE MOST SAFE LIFTING MAGNET IN THE WORLD

PERMANENT ELECTROMAGNETIC TECHNOLOGY
Electric current is only used to invert the magnetic field, while the effective force is generated by permanent magnets.
In the event of a power failure, the magnetic force remains constant = 100% safety

SAFETY RATIO 3: 1
For safe lifting, it is necessary to take into account the possible air gap between the contact surface of the magnet and the steel being lifted. This is why all our magnets are designed with a minimum safety factor of 3: 1 with a 0.4mm air gap.

LOAD STATUS DETECTION
An inductive proximity switch and an associated cam attached to the lifting chain prevent accidental demagnetization in the air.

LIFTING CYCLES
The ascent is carried out in 2 stages:
first, the part is lifted with a lower set force, and then immediately in FULLMAG mode (100% of the total force).

2 BUTTONS
To start the demagnetization cycle, you must successively press 2 buttons (SAFE + DEMAG) on the remote control.

REMOTE CONTROL
The magnet is operated from a safe distance. The operator should not be in the immediate vicinity of the load.

SIGNAL LAMP UNIT
The state of the magnet is visually indicated by a transparent LED block. The load can only be moved when the green lamp is on continuously!

INSTRUCTION PANEL
With clear safety instructions for the operator regarding:
- Maximum dimensions of the cargo depending on the thickness of the material
- Maximum overhang depending on the dimensions of the material

SPC SYSTEM ( SYSTEM OPERATION CHECK)
An electronic system constantly monitors the correct functioning of the traverse. Any abnormal situation is immediately reported and indicated by an error code on the screen. In this way, errors can be immediately analyzed and corrected.